ZoiPer 3 - Configure Microphone and Speaker

Windows Instructions

Zoiper comes with a built-in Audio Wizard for easy configuration of your microphone and Speaker.

You may access this Audio Wizard by:

• Clicking on the speaker icon on the bottom right
• Clicking on the Settings menu in Zoiper and selecting Audio Wizard

Zoiper will configure your Speakers first.

Click on the “start the test” – button.

If your speakers are configured and connected properly, you should hear a ringing sound. If you do, please click on the Yes button and move on to the Microphone step.

If no ringing sound was heard, please make sure your speakers are connected properly and powered on and if needed change the selected audio device on the bottom of the page to a different one and try again by clicking on the “no” – button.

Click on the “Test your microphone” – button to start recording your voice.

If the selected microphone is connected properly, you should see the volume meter move when speaking into the microphone. If the volume meter is not moving, please check your cabling and make sure the proper audio device is selected in the Device section on the bottom of the page.

Once the microphone and speaker are configured properly, click on the “yes” - and the “ok” to move on to the webcam configuration screen.

A list with webcams will appear on the bottom. Please select the webcam to use and confirm that the image is shown by clicking on yet. If no webcams appear, please make sure that your webcam and webcam drivers are properly installed in windows.

Clicking on ok will close the configuration panel.

MacOS X Instructions

Zoiper comes with a built-in Audio Wizard for easy configuration of your microphone and Speaker.

You may access this Audio Wizard by:

• Clicking on the speaker icon on the bottom right
• Clicking on the Settings menu in Zoiper and selecting Audio Wizard

Zoiper will configure your Speakers first.

Click on the “start the test” – button.

If your speakers are configured and connected properly, you should hear a ringing sound. If you do, please click on the Yes button and move on to the Microphone step.

If no ringing sound was heard, please make sure your speakers are connected properly and powered on and if needed change the selected audio device on the bottom of the page to a different one and try again by clicking on the “no” – button.

Click on the “Test your microphone” – button to start recording your voice.

If the selected microphone is connected properly, you should see the volume meter move when speaking into the microphone. If the volume meter is not moving, please check your cabling and make sure the proper audio device is selected in the Device section on the bottom of the page.