Introduction
The Cisco SPA112 2-Port Phone Adapter enables seamless integration of analog devices, such as telephones and fax machines, with VoIP services provided by Masiero. It features two telephone ports, an Ethernet port, and a compact design, making it ideal for various environments.
Power cycling is a simple yet effective troubleshooting step for resolving common issues like faxing problems or analog phone connectivity. Follow this guide to safely power cycle your SPA112 device.
Where Is the Cisco SPA112 Typically Located?
The SPA112 is commonly found in one of two locations:
-
Near the Fax Machine
• Within 3 to 5 feet of the connected fax machine or analog phone.
-
In IT Closets or Equipment Areas
• Mounted on racks, shelves, or in a central networking area for easier access.
In some cases, its placement may vary depending on environmental or operational requirements.
What Does the Cisco SPA112 Look Like?
The SPA112 is a compact unit, approximately 4" L x 4" W x 1" H.
-
Front: White lettering with “2-Port Phone Adapter” label.
-
Rear:
-
Two telephone ports: PHONE 1 and PHONE 2.
-
Ethernet port: INTERNET.
-
Power port: DC 5V POWER.
-
How to Power Cycle the Cisco SPA112
Steps to Power Cycle:
-
Disconnect the Power Cable
-
Locate the DC 5V POWER port on the rear of the unit and unplug the power cable.
-
Verify that all indicator lights on the top of the device turn off.
-
-
Wait Five Seconds
- Allow the device to remain unplugged for at least five seconds to ensure a complete reset.
-
Reconnect the Power Cable
- Plug the power cable back into the DC 5V POWER port.
-
Wait for the Device to Reboot
- The SPA112 will take two to three minutes to boot up and become fully operational.